Forum Replies Created
-
Andy Coles
MemberOctober 8, 2018 at 8:21 pm in reply to: Vertical Board cutters, advice needed please?Try the vertical panel saws at http://www.axminster.co.UK. for 8×4 sheets just over 2k. For 3m x 1500 sheets about £2700 (the one we have). Excellent bits of kit for the money
-
Bricklayers chalk line from top of wheel arch to top of wheel arch, works every time and gives a nice blue chalk line to work from. Cheap as chips from screwfix etc.
-
Sounds like you really need to book a holiday, get back and book another one straight away. Look forward to the time you’ll be sharing all your experiences with those grandchildren and taking them under your wing. No need to retire just refocus a little maybe!
-
Andy Coles
MemberSeptember 21, 2015 at 8:20 pm in reply to: Machines gone bang – engineer required south London please.If you’re lucky it will have only taken out initial fuses, these are quick blow type which are similar to those in a microwave, might be able to source from a kitchen appliances store, your manufacturer ought to be able to give you spec if you’re not confident in locating in machines yourself. Good luck
-
Andy Coles
MemberSeptember 21, 2015 at 8:14 pm in reply to: Printer port problem with error message – help please?Try going into pc settings and restore to a recent restore date when you know it was working fine,
good luck -
Interesting
What SIC code did you specify?
Thanks
Andy -
Andy Coles
MemberFebruary 27, 2015 at 10:43 am in reply to: Feedback on Neolt trimmers / laminators please?Think you’ll get A09 when you switch on – maybe you have left the rollers down.
Move roller up, switch off and back on again and you should be OK.
Don’t leave rollers down when not in use or you will end up with flat spots on the rollers.
Cheers
Andy -
Andy Coles
MemberNovember 24, 2014 at 3:44 pm in reply to: Feedback on Neolt trimmers / laminators please?WOW Just checked and ours is a 1650c too! Run it for 8 years plus without any problems, used most 7 days a week.
Great reliable machine. -
Andy Coles
MemberSeptember 22, 2014 at 8:26 am in reply to: Fool proof way of getting a cutline – recommend software?Try installing Vectormagic, great program and will do it for you.
-
We’ve also had the Neolt Neolam for a number of years and can reccommend. Think they were originally branded under a different name and marketed as a package bundle with some printers (maybe via Roland dealewship) They were at Sign uk in 3013 by Atlantic Tech Services, Ilford, Essex Tel 01992 561 300
-
Going back some 20years we had the same problem on a graphtec plotter which odly enough was caused by a screen saver. If you have an active screen saver try turning it off. It certainly worked for us!
-
Andy Coles
MemberJune 3, 2014 at 2:54 pm in reply to: How do you measure "Signs" up high ? What tools doAlso worth logging in to your local planning office portal,
search by address and you may find drawings etc. Often check on weekly lists for planning decisions for developments where signs may be needed.