Karl Williams
Forum Replies Created
-
HI MATT,
SECOND DESIGN IS SPOT ON! COLOURS GO WELL. I ALWAYS GET SOMEONE WHO WILL CRITICISE A DESIGN. TRY IT AND TEST IT. THE RESPONSE FROM NEW CLIENTS IS SURE TO BE A GOOD ONE!CHEERS,
KARLmod-edit
-
IF YOU’RE DEAD SET ON BUYING A ROCKY 38 THE BEST CUTTER TO GO WITH THIS IS THE SUMMA S CLASS 120. WORKS WELL WITH CORAL AND ONYX. I FOUND THE ULTIMA TO BE, WELL LETS SAY NOT THE BEST.
-
I’M ON MY SECOND ROCKY. THE FIRST WAS NOT GOOD AT ALL. YOU COULD NEVER GET THIS TO PRINT CORRECTLY. THE SECOND MACHINE IS A REAL STAR!!!! LOST A LOT OF BUSINESS FROM THIS AND THE SUPPLIER WAS NOT IN THE LEAST BIT INTERESTED.
-
HI RICHARD,
YES, I’M USING THE ULTRA INKS. I NORMALLLY PRINT ONTO MACTAC FROM AMARI DIGITAL SUPPLIES IN NOTTINGHAM. VERY GOOD! NOW IT’S HAD THE UPGRADE IT PRINTS NOT TO BAD ONTO THE MACTAC 8300
VINYL. YOU’RE NOT SUPPOSED TO PRINT ONTO THIS BUT IT DOES SEEM TO WORK. SAVES ON BUYING A FULL ROLL AS WELL! WHERE DID YOU BUY YOUR MACHINE FROM? HAVE YOU TRIED THE VOLTAGE YET? -
HI MAURICE,
UNDER THE PRINT HEAD CASING TO THE RIGHT YOU MAY NOTICE A BUILD UP OF FIBRES FROM THE SPONGE IN FRONT OF THE CAPPING STATION. THE PLASTIC HOUSING FOR THIS SPONGE TILTS EVERY SO OFTEN CAUSING THE HEAD CARRIER TO CATCH. THIS TAKES FIBRES AWAY ACROSS THE PRINT AND LOOKS LIKE A HEAD PROBLEM. CLEAN THE SPONGE, REMOVE THE FIBRES AND ALSO THE RUBBER BLADE. DON’T TOUCH THE BLADE WITH YOUR FINGERS, USE A COTTON WOOL BUD. THEY SAY DONT USE METHS, BUT MY MACHINE WORKS FINE NOW.
YOU MUST DO THIS EVERY WEEK, AND IT ONLY TAKES 5 MINUTES! -
MAYBE AN ELECTICIAN COULD SORT IT OUT IF ITS OUT OF WARRANTY!!!
I CAN GUARANTEE THIS IS YOUR PROBLEM. MANY WERE SENT OUT FROM THE MANUFACTURERS WITH THE SAME PROBLEM. REAL BUGGER WHEN YOU ARE HALFWAY THROUGH A BIG JOB!!!!!!!! -
HI RICHARD,
I HAVE A ROCKY 38 AND HAD THIS SAME PROBLEM. YOUR ANSWER LIES IN THE VOLTAGE OF THE MACHINE. IF THE VOLTAGE IS TO HIGH THE TIMING IS OUT AND CAUSES THE ONYX TO GO ON A BENDER.
MINE WAS SET AT 5.15 AND IF I REMEMBER CORRECTLY IT SHOULD BE 4.2. THIS IS IN THE CASING UNDER THE PRINTER.
THE BEST PEOPLE TO ASK IS ARTSYSTEMS. VERY HELPFUL!!!!!