Forum Replies Created
-
Rob Thorner
MemberJanuary 29, 2023 at 3:04 pm in reply to: Using Impact Vehicle Library with IllustratorMany thanks for your help. I will try scaling up in the cutting software then. I always jot the panel measurements down and go by that anyway – old school keepin’ it real🤟 – but this will make it easier, thanks a lot
-
Rob Thorner
MemberNovember 10, 2022 at 12:37 pm in reply to: Ink scrubbed off sign? will it show up under a vinyl wrap?Thanks for the advice guys. I will have a closer look tomorrow to see if it can be covered over, and if not will replace with another aluminium panel.
Thanks again
-
well thanks friends for all your help, i just looked at the weather for 2moz but its dry touch wood, still cold though. ill use the heat gun for that,
thanks again -
ok then friends, thanks for the advice, im going to see him tomorow. ill try to persuade him to take a new board,
thanks again – rob -
ok then, thanks for the advice, ill start using a stanley knife while i still got all my fingers
-
well thanks eversomuch for the quick reply jill, thats useful, ill askaround, ive been looking on the internet but no luck.
thanks again -
Rob Thorner
MemberAugust 20, 2020 at 4:37 pm in reply to: Vehicle Measurement Software, advice needed on source please?Ta mate
-
Rob Thorner
MemberAugust 20, 2020 at 4:34 pm in reply to: Vehicle Measurement Software, advice needed on source please?Ok nice one, Brian’s one it is then. Many thanks!