Im a bit late now but…We normally wrap over them, trim to the edge of the bumper "hole" carefully, then for the middle I measure the centre circle diameter, and put a piece of wrap through the cutter (Dont forget to set the pressure) and they look spot on. Never had an issue yet.
setting – substance – substance handling – right hand edge (check what’s been put into this box).
In Onyx:
Placement – general (check on offset has been entered & justification is centre).
Thanks Colin, pretty much what ive fumbled my way around to doing – all be it a strange combination of things between the printer itself and Onyx but im happy its working now. Appreciate the help :thumbsup:
Report
There was a problem reporting this post.
Block Member?
Please confirm you want to block this member.
You will no longer be able to:
See blocked member's posts
Mention this member in posts
Invite this member to groups
Message this member
Add this member as a connection
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.