[Simon Burns]

Hi

Yes i’ve just checked and the pairs of colours are T junction connectors at the back, but there is enough slack to be able to remove the T and reconnect the colours back up. I’d then flush the LC and LM lines and completely replace the other two for white along with the dampers.

Next question though: Could I assign the colours to be C Cl M Ml Y _ K _ so that a line flush would allow me to go from 4 to 6 easier or does the swap to 6 colour have to be C M Y K LC LM _ _ where completely different colours need to go down the lines requiring completely new lines and dampers?

• This reply was modified 3 years, 1 month ago by  Simon Burns.

[Simon Burns]

Thanks for that Jamie.

My problem is I want to check the printer is all working properly for the least outlay (ie: just get 4 CMYK cartridges for now) and then if all good add white, as I want to eventually print on clear film. Is there a way to set them up as 4 colour and white or do I have to add the LC and LM to have white as well?

[Simon Burns]

SS21