Forum Replies Created
-
Richard
MemberOctober 14, 2022 at 8:41 am in reply to: Help choosing suitable digital print material for the Mimaki CJV30-130Thanks Allister for your reply,
We mostly use Metamark MD5 & MD I along with their banner material, but we’ve been experiencing the material “rippling” while been printed, it would be interesting to know what printer heat and print profile settings other people use without a problem so we can compare them with ours.
Richard
-
Richard
MemberJanuary 15, 2021 at 3:21 pm in reply to: Transit Custom side & rear panel contour cut line requiredHi
Thanks everyone for your advise,
I currently use the “impact vehicle library” publications and have found them very good, but unfortunately no accurately enough for what i’m trying to do. I do appreciate the constructive help from those concerned Thanks again. 🙂
Richard
- This reply was modified 3 years, 3 months ago by Richard Thompson.
-
Richard
MemberOctober 31, 2022 at 5:10 pm in reply to: Help choosing suitable digital print material for the Mimaki CJV30-130Hi Jamie
We are using Fincut 9 with Rasterlink 5SG rip.
Richard
-
Richard
MemberOctober 31, 2022 at 4:32 pm in reply to: Help choosing suitable digital print material for the Mimaki CJV30-130Hi Jamie
Just tried a print using the print heater settings you use on your Mimaki and the rippling has gone away for now! Wow. I will see how we go one with some more print we will be doing soon.
Just for record what Print profile settings do you use commonly with the Heat settings?
Thank you for your help
Regards
Richard
-
Richard
MemberOctober 25, 2022 at 1:38 pm in reply to: Help choosing suitable digital print material for the Mimaki CJV30-130Hi Robert,
Thanks for the information, very helpful.
Regards
Richard
-
Richard
MemberOctober 20, 2022 at 1:40 pm in reply to: Help choosing suitable digital print material for the Mimaki CJV30-130Hi Robert
Thanks for reply, the room that our print media is stored in is dry, but not heated, the print media is stored off the the floor on stands. I have the same issue even printing with a new roll out of the box. I may try the Avery brand next time, who do you recommend as a supplier?
Thanks
Richard
-
Richard
MemberOctober 20, 2022 at 1:31 pm in reply to: Help choosing suitable digital print material for the Mimaki CJV30-130Hi Joe,
Its interesting to hear that your having the same issue with Metamark rippling, ours to starts to Ripple for about 10-15m on the left side, and as a result I have to watch the machine printing to avoid a head crash. Can I ask what printer you use that’s having this issue – Its not a Mimaki CJV- 130 is it? :))
Thanks
Richard
-
Richard
MemberOctober 20, 2022 at 1:22 pm in reply to: Help choosing suitable digital print material for the Mimaki CJV30-130Hi Jamie
Thanks for the info on the printer heater settings you use, I will adjust me heaters to the same settings and try a print, also going to look at how we store or print media. otherwise I’m going to try the Avery brand media and see how we go.
Thanks again
Richard
-
Richard
MemberJanuary 13, 2021 at 4:13 pm in reply to: Transit Custom side & rear panel contour cut line requiredHi David,
I was just asking a simple question, sorry to upset you. maybe someone else an help me?
Richard
-
Thanks Jamie, appreciate the help