Forum Replies Created

  • Buck

    Member
    August 6, 2002 at 8:16 pm in reply to: SignGo software

    what do you mean? When I went to cut. the cutter started and then it finished that graphic and started again on the same one and cut through the backing paper. then it started on the same graphic again.

  • Buck

    Member
    August 5, 2002 at 10:00 pm in reply to: SignGo software

    The one time I did use the Signgo Lite when I went to cutting it double cut the graphic and it went to cut it a third time but I stop it. What causes this.

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .