Forum Replies Created
-
Martin
Thanks very much i’ll give that a try
Cheers
Rich
-
Rich Fereday
MemberFebruary 4, 2012 at 4:22 pm in reply to: Pcut630 – trouble setting knife and cuttingGents
Thanks very much.
Yes the cutting strip does have a "cut mark" in it.
I’ll look to replace this.
Cheers
Rich
-
Rich Fereday
MemberFebruary 4, 2012 at 12:23 pm in reply to: Pcut630 – trouble setting knife and cuttingDear All
Thanks for the previous advice, the smart knife worked wonders!!
However, I’m now having problems with cutting, I’ve set the compensation, pressure and speed but am not getting consistent cut’s, the media doesn’t seem to be held in place tight enough, when cutting it "ruckles" up.
I’m cutting heat transfer vinyl.
I’ve unrolled the media, cut a section to use so it feeds through, but still can’t seem to resolve the problem.
Does anyone else with a pcut 630 have these problems or a solution (?)
Cheers
Rich
-
Rich Fereday
MemberJanuary 19, 2012 at 2:09 pm in reply to: Pcut630 – trouble setting knife and cuttingBrian
Thanks very much for this.
Sounds like a plan to me!!
Cheers
Rich
-
Rich Fereday
MemberJanuary 19, 2012 at 10:39 am in reply to: Pcut630 – trouble setting knife and cuttingGents
Thanks very much for this, thought it might be a case of trial and error!!
Cheers
Rich