Forum Replies Created

  • Jason Butt

    Member
    October 15, 2009 at 4:03 pm in reply to: Hello from Nottingham

    thank you

  • Jason Butt

    Member
    October 15, 2009 at 7:29 am in reply to: Foison c24 plotter cutting rubber, advice?

    So carrierng on with this subject could anyone please advise on how to inport a image into signblazer so I can cut the out line of the image when I send it to my plotter as I’m working in sand blast rubber and at present I only require the outlines

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .