Forum Replies Created

  • Goodwin

    Member
    April 20, 2008 at 7:52 pm in reply to: can anyone help please with blade pressure on Pcut 630?

    Thanks for the reply, and from a fellow Welsh man too! Where you based? I wont be stepping on anyones toes as my cutting is for my wifes pet shop and vehicle.

    I think I have my blade press set at around 120 at the moment! Anything less and it wasn’t cutting through to the backing.

    I will check the cutting strip, Ive had success in cutting since posting the thread but not major, I have had it cut most of the image but it always seems to snag at some point!
    Ive only been using the vinyl that came with the cutter at the moment so will buy some fresh and give it a go.

    Grateful for any further info/advice.

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .