David Matthewman
Forum Replies Created
-
its just a vector , but i’ve worked out what was wrong or not helping , which was to down save 😀 😀 to illustrator 8 when exporting and now works yey , thanks for help , i was going to give up or buy some thing new i can’t afford ,
now that i can use corel is there any way to cut directly or is that going to just be a pain to work out and would it save much time , thanks -
no joy advantage starts to import then stops and shows error , if i could cut from corel that would be easier but i don’t have a driver for fastrack and it doesn’t seem see it , do i need driver or a plug in or more software , i have two pcs , the advantage is on win98 and corel is on xp , thanks
-
ah i didn’t try export as ai file , will give it a go now , thanks
-
David Matthewman
MemberNovember 27, 2013 at 2:38 pm in reply to: in need of a cable for a fastrack 1300thanks i’ll have a look
-
plus we used to get wrinkles at the beginning on the roll so pull the vinyl through
200 mm before gripping it , on the artwork we would put a full stop about 2 inches
in front so it wouldn’t start cutting right on the edge of the vinyl ,
Dave -
hi i’m new on here ,but used the fastrak for years , you will get that wavy edge
around curved parts , if the letters or numbers are small and speed is to high ,
we ran ours on min , check the blade is clean sharp and able to rotate ,
the grip wheels need to be clean and vinyl straight and flat on the bed ,
use a smart blade
if your not sure how to remove and insert the original ,
depending on your software
you can adjust sharpness and corners as well , hope this helps
Dave