Forum Replies Created
-
its possible just to keep using signblazer elements as a demo
-
colin rawson
MemberJune 1, 2007 at 11:03 am in reply to: Viewing .EPS Files, is there a freeware viewer?i found this not sure if its what you are looking for but heres the link
not sure if ive posted the link right
iam new to this i know what its like to find the sw you are looking forcheers
-
colin rawson
MemberMay 31, 2007 at 7:00 pm in reply to: Which blades are the correct ones to use on pcut 630 please?thanks for the replies will order 45 degree 1s
thanks to all
colin
-
colin rawson
MemberMay 31, 2007 at 5:22 pm in reply to: Which blades are the correct ones to use on pcut 630 please?it says on the back of the vinyl
ri-mark series l&m
if that meens anything
thanks
colin
-
colin rawson
MemberMay 30, 2007 at 8:19 pm in reply to: what software is suitable to use with pc-cut please?my cutter should here in the morning ordered from signwizard
with signblazer elements
and some vinyl to practice with
looking forward to giving it ago ive read loads of posts
wich have been very helpful just need to get some fonts + logos
to help me not very good at drawing
but thanks everyone for your help
colin 😛
-
colin rawson
MemberMay 27, 2007 at 8:30 pm in reply to: what software is suitable to use with pc-cut please?thanks for the info
looks like iam gonna buy from signwizardthanks
colin
-
colin rawson
MemberMay 27, 2007 at 7:35 pm in reply to: what software is suitable to use with pc-cut please?it was 1 off ebay but the seller has messed me about
so iam still looking for a bargain
i see signwizard sells them on ebay
thanksfor your reply
colin