since I am trying to set up an old Summa D1010 and having difficulties getting anything out, I stumbled upon your post here.
Just wanted to ask you what hp driver you used and what you meant by "switched the cutter to accept the command format" – could you explain that a bit more in depth, please?
thank you, Colin, I will try!
(did run the set ups in admin mode…)
best regards – Christoph
Report
There was a problem reporting this post.
Block Member?
Please confirm you want to block this member.
You will no longer be able to:
See blocked member's posts
Mention this member in posts
Invite this member to groups
Message this member
Add this member as a connection
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.