Activity Feed › Forums › Sign Making Discussions › Vehicle Wrapping › Wrapping with cast film

  • Vehicle Wrapping

    Wrapping with cast film

    Posted by Simon Worrall on September 16, 2013 at 1:47 am

    Hi
    I have a client wanting 4 pickups part – wrapped with a particular teal colour.
    3m does it in their 7795 range. However, it doesnt have the air release glue and I am not good enough to wrap with this. I cant find an alternative teal with air release.

    What I am thinking is this. I laminate the 7795 to a sheet of IJ 180cv3 in the workshop, and then wrap it.

    Will this work? Is the 7795 conformable enough to take it without pulling back?

    Simon.

    Simon Worrall replied 10 years, 7 months ago 2 Members · 2 Replies
  • 2 Replies

  • Jon Marshall

    Member
    September 16, 2013 at 10:20 am

    That should work ok. Or you could laminate the base vinyl to make it thicker and easier to handle.

  • Simon Worrall

    Member
    September 25, 2013 at 10:33 am

    John thanks for the reply

    I laminated the coloured vinyl to a sheet of 3m IJ 380.
    I covered a complicated back bumper with it and it It went on like a dream.
    After a week it shows no signs of wanting to pull away.

    Simon.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .