-
Vinyl Master Pro Demo – where can I get it?
Lo all 😛
has any1 any idea where i can get a demo for VMP, iv found a old old site that had a d/l demo but i think its ver 1 😕 bit long in the tooth i think, its ver 2.7 atm. Iv filled in the form to get a cd sent from here
http://www.vinylmasterpro.com/united_kingdom/software.htm but i think thats from the usa so may not get sent not sure though.
Been reading the old forum posts about VMP and for the price it seems a lot of very good feedback and ppl like it. :lol1: -
5 Replies
-
if you pm me your address details I`ll look out my demo version for you.
i did buy the full product, but couldn`t get used to the welding module.
it does have some good features that signlab/cadlink should take a look at.
-
I filled out the online application for a demo CD and had one sent to me, I believe Graphityp are the UK agents for the software. I think you will also find that the demo version is quite dated, its certainly not the latest version. I looked at it because you also get future rip with it and as I was looking for a rip and all the ones I looked at were a bit to expensive for me I thought this would be a good idea, but there isn’t a lot of support for my printer in terms of icc profiles.
-
Soz i carnt PM Becky silver membership atm no PM but if you can view my profile you will see all my details there, and thanks :lol1:
Profiles are not a prob for me Martin as this is for a cutter only, i noticed some earlier posts(https://www.uksignboards.com/viewtopic.php?p=91437&highlight=vmp#91437) on the subject of VMP and a few guys said it would not work with there Graftec 3000’s and some others said it was fine, i think Ian Gordon said it worked fine on his Graftec, hope it works ok with the 3000-120 lol or the wife will go spare 🙄 Thats about 3 pairs of her stilleto shoes the price of VMP 😛 -
i use this software on a roland camm machine and no problems..
graphityp sell it in the uk..but dont support it..Jon
😀
-
Jon,
The only reason we do not actively support it is because that’s the deal with the software writers, we do offer advice/support where and when we can.
It does go against the grain for us because it puts us in a awkward position.
Nigel
Log in to reply.
