-
Versa Camm
Hi All
Richie here, new to the site, 😀
Have been reading the information on the Versa Camm over the past few days, it has been very informative , but i have a few Questions
I was too see the Versa Camm, at a demo, seems very impressive and am thinking seriously of getting one.
1. Is it competive for making labels, and what is the best Materials.
2. As i have samples, i did the finger rub test and the vinyl test, no running at all, is that down to the material ????
3. The banner material used is without eyelits, is it expensive to buy a machine for this,
Cheers (hot)
Richie
-
4 Replies
-
hi druid mate and welcome.
I also went to see the vercecamm and i couldent rub it off either
as regaurds to putting ring holes in the banner i dont think its very dear
as far as i know its just a handheld punch. -
lost is right! hammer and hand held punch. very cheap.. the hems/welder if you want them also are a bit more exspensive. 🙄
-
Cheers Lads
As i was always using Bananna Banner, i had no need for the getting the system for punching eyelits, where wuld i pick it up??.
Richie 🙂
-
Try any upholstery shop – they are real cheap
for Hemming , we use an industrial type overlocker sewing machine – Cost in the region of GBP 150 , 2nd hand but works well
My ladies also do rosettes and some drawstring pouches etc with it ( some of em come from a CMT environment)
Log in to reply.
