Activity Feed › Forums › Printing Discussions › Roland Printers › Stop heater coming on on vs-640i

  • Roland Printers

    Stop heater coming on on vs-640i

    Posted by Daniel Evans on July 5, 2016 at 9:55 am

    Hey guys

    I need to cut some sandblasting material but I don’t want the heater coming on as it seems to cut much better when I do the first one.

    I set the heater controls on the cut file to off but the heater is still on, can anyone tell me how to turn it off just for cutting?

    Also has anyone cut sandblasting material before as is there anything special i should be doing?

    Thanks

    Daniel Evans replied 7 years, 10 months ago 2 Members · 2 Replies
  • 2 Replies

  • Emyr Evans

    Member
    July 5, 2016 at 11:24 am

    In the function menu go to heater config, then press arrow right, press right again and use up down arrows to increase or decrease heat. Press enter, then left arrow, then go down and follow the same procedure for the other heater.
    Hope it makes sense!

  • Daniel Evans

    Member
    July 5, 2016 at 1:08 pm

    Thanks Emyr

    That helped.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .