Posted by Chris Wool on February 26, 2013 at 4:16 pm
who uses what make please
is the film finished just inside the panel area or goes over the edge.
making some of the templates would be ok so that a nice finish in the middle of a panel
just trying to compare with bought in ready cut film
The protection film doesn’t usually go over the edge of a panel but stops a couple of mm short. Mainly because the chance of a stone hitting that small of an area is very small.
We tend to use Suntek branded or Solutia (CP Films) due to discounts for the amount of window film our companies buy.
Edit: We’ve bought in pre cut and made our own depending on vehicle etc.
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.