Activity Feed › Forums › Printing Discussions › Uniform Printers › Old Troop rip (flexi) Advise

  • Uniform Printers

    Old Troop rip (flexi) Advise

    Posted by Stephen Morriss on May 27, 2010 at 7:45 pm

    Hi

    I’ve just bought an old Uniform Cadet + and it came with troop rip which is based on flexi (not the later troop based on Wasatch)
    How do you set it up to print, laminate and cut using the printers auto alignment marks?

    I already have a SP300 and I use Wasatch’s upgrade from colorip so I’m used to Wasatch.

    Or

    Can I use Wasatch with the Cadet +, I’ve tried and while the rip could send the file to the tcp/ip port the printer came up with an error, maybe I have the wrong printer driver selected but I can’t find an SP-540 specific driver in wasatch, just the SP-300 driver and lots of other Roland drivers but no SP-540.

    Thanks
    Steve

    Stephen Morriss replied 13 years, 11 months ago 1 Member · 1 Reply
  • 1 Reply

  • Stephen Morriss

    Member
    May 29, 2010 at 6:35 pm

    No one?

    Oh well, I’ve got Versaworks off Roland now so I just have to try this and see if the profiles are any were near for the colorific/activasol inks.

    Steve

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .