Posted by Paul Munford on June 4, 2008 at 12:56 pm
Hi,
Can anyone advise as to a good vinyl mask for wood.
I have approx 1500 small logos approx 150mm square to stencil on to unfinished softwood using plastikote aerosol paint this W/E!
Cheers,
Paul.
Thanks for the response barney.
The job was completed using ri-mark banner vinyl from Doro-tape
The stencil was 33 square meters and had over 500 Nike logos cut in it.
After trying various different vinyls we found banner vinyl worked really well as it is very flexible and didn’t react with the spray paint.
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.