-
Good quality Blockout PVC… suggestions needed
Can anyone recommend and where to purchase a 30meter roll of 550gsm block out PVC that can be printed on a mimaki JV3 solvent printer with equal quality on both sides, i need a roll in approx 1meter width.
The last roll i used printed ok on one side, but was very poor on the reverse due to surface imperfections, I’m looking for both sides to be smooth and printable.
Thanks in advance..
-
2 Replies
-
i been looking for something similar but transparent based and thick on a roll.
i did try and print both sides of Hydrasol on our UV and the good side stuck ok and the bad side didn’t have good adhesion and from memory it works well on the JV3 except the second side.
-
hi Andy
i use so-yang block-out banner from victory design
and have just got a roll from grafityp to try over the next few days. the grafityp is a bit more expensive but its a 50m roll not 30m and they do free slitting.Robert
Log in to reply.
