Corel 12 Problem

[graffica]

Hello Darren.

Have a look in "wireframe".
Delete all the rectangles in the background.
Select the bitmap only.
Edit in Corel Paint by cropping only the part you need.
Save the changes.
Place the bitmap back in it´s original position.
Select all and convert to bitmap …. 600 dpi or whatever quality you want.
It then printed perfectly on my Epson CX 6600

This might be a long-winded way of going about it, but it works.

You could try converting 1 complete image to a bitmap before you do the above.

All the best. Chris.

[Darren Mooney]

Thanks Chris! Had the regtangles in to black the background jpg out, lazy way out of cropping! eventually cropped it properly but it still went the same way! never thought of converting to a bitmap! was too busy getting frustrated about why it wouldn’t print! they were needed for this morning, so it was a late night! Was using it as part of the xpres ultragraphics system, loaded into my roland cx24 to cut using the opus eye, all seemed to be going well until I saw where it cut… it was as if the design had been gradually elongated… tried adjusting numorous settings, page size, position on the page etc, but it still cut the same elongated line, will scan a result for autopsy later! ended up goind around the whole lot of them with a scalpel!