uksignboards.com - Contour Cut

General Cutter topics

Contour Cut

Posted by Dave Bruce on August 29, 2004 at 9:20 am

Just wondering if anyone has done contour cutting with a Roland Camm-1.
I was wanting to buy a printer then contour cut the printed vinyl on my cutter. I believe you can buy an optical sensor for it, but just wondered how accurate it would be etc.

Cheers

Dave

David Evans replied 20 years, 5 months ago 5 Members · 5 Replies
5 Replies

Shane Drew

Member
August 29, 2004 at 11:48 am

I use the Roland 1000mm Camm 1 but I have never heard of a sensor adaptor at all, sorry.

I’d imagine the accuracy would be in the software though. I have had my cutter for 6 or 7 years, and only ever replaced the rubber wheels on the grips.

Never had an ounce of trouble otherwise.

Cheers
Dave Springate

Member
August 29, 2004 at 12:46 pm

Hi Dave,

Is this what you are after?

http://www.xpres.co.uk/ultragraphics.html

Dave
Dave Bruce

Member
August 29, 2004 at 7:30 pm

yer Dave that is the type of sensor I am looking for, but to fit my Roland CX500.

Cheers

Dave
Kevin.Beck

Member
August 29, 2004 at 8:08 pm

I`m looking for a similar plotter.

I don`t think you can buy an adapter. You have to buy the plotter with the laser system attached…
David Evans

Member
September 1, 2004 at 11:18 am

What software are you using ?

If its Signlab, I will check, but am pretty sure you can just use our three point optical reg marks.

Best regards

-David Evans
Cadlink.

Log In to Reply

Log in to reply.