Activity Feed › Forums › Software Discussions › Corel Software › Connecting Corel to Roland CX500 plotter

  • Tim Painter

    Member
    March 25, 2008 at 12:19 pm

    Drivers should be available from Rolands site.

    Most likely line widths will have to be set to 0.01 as they have been in the past to be able to cut using the driver direct from Draw.

    Tim.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .