can anyone help me with cadet plus error code please?

[Phill Fenton]

Don’t know what it means – but I’ve had this before. Just switch of and back on again to clear it.

[Derek Heron]

hi steve sounds like one i sometimes get with a big log of vinyl and i forget to pre wind out .and the motor struggles to pull it sometimes also happens when winding forward a few metres of vinyl.
bit of a pain but switch off cadet and leave a few seconds and restart
hope this helps
derek

[Steve Coyle]

Thanks guys, I’ve tried all that, no luck, I’m wondering is the scan motor the one that powers the head. I’ve had the other scan message when I didn’t roll of the vinyl once or twice, but never this one. I wouldn’t mind only I’ve got a load of gear to get out for the big Paddy’s day celebrations…..

[Kevin Flowers]

Steve
check that the head can move across freely, do you get it if the cutter head travels on its own or when its with its print head assembly.
Sometimes it can be caused by a build up of dirt & dust on the linear slide causing the bearing to struggle to run. Wind your head carriage down & check nothing is stuck with dried ink etc it doesn’t take much to trip these errors.
Best of luck

Kev

[Steve Coyle]

Thanks Kevin, no joy but I’ve noticed that the capping station isn’t coming up to meet the print heads,