Activity Feed › Forums › Vinyl Cutter Discussions › Graphtec Vinyl Cutters › can anyone help me source a cutting mat for Graphtec please? Graphtec Vinyl Cutters can anyone help me source a cutting mat for Graphtec please? Posted by Adrian Neill on September 25, 2008 at 2:20 pm Good afternoon …… I’m after some more supplier advice. Anyone know where I can purchase a new cutting mat for a Graphtec Pro FC4100-130 ?? I’ve contacted Graphtec but they haven’t responded to any of my queries. 😥 Adrian Neill replied 15 years, 7 months ago 3 Members · 3 Replies 3 Replies Peter Normington Member September 25, 2008 at 7:49 pm did you use the telephone to contact them? I never had a problem getting bits from them Peter Jayne Marsh Member September 26, 2008 at 9:29 am You should have no problems ringing them and ask to speak to consumables Adrian Neill Member September 29, 2008 at 9:29 am managed to speak to them and get the part in the end. They’ve sent something through but not sure it’s the right bit. 😕 Log In to Reply Log in to reply. Public All Members My Connections Only Me PublicAll MembersMy ConnectionsOnly Me Public All Members My Connections Only Me Log In to Reply Start of Discussion 0 of 0 replies June 2018 Now