-
BN-20 Print & Cut in batches?
Hello,
This is my first post.
I’ll just start by saying that this forum has helped me a lot with the decision whether to go ahead with the purchase of a new Roland BN-20 machine. I got the machine from Grafityp a couple of months ago. Thanks to everyone who has shared their experiences of the BN-20 and VersaCAMM machines on here.
I’d like to know if it’s possible to send one single job to print so that the machine performs in the following sequence:
Print and cut, print and cut, print and cut, print and cut
rather than:
Print, print, print, print, cutHopefully to keep the cutting accuracy to the highest level, without having to send the same job to print, over and over again?
I understand that this might be possible with a VersaCAMM, but I’m not sure if it is with a BN-20?
Thanks for any help.
Chris
-
2 Replies
-
never done it but its to do with setting a page length in custom cut.
in layout.
so it will do a page worth then start another page.best i can do
-
quote Chris Wool:never done it but its to do with setting a page length in custom cut.
in layout.
so it will do a page worth then start another page.best i can do
Thanks Chris,
I might try that with a smaller sized job, just in case.
Log in to reply.
