-
A Board Supplier
Ok I have searched the boards for the last 12 months (posts) but can’t find a supplier of a specific type of A Board, so hope someone can help.
They make them out of steel both round and square have black caps and ‘feet’ and have 10mm Foamboard as the face. Come with stainless pin hinges and a centre lock to hold them open.
Hope someone recognises the description.
Cheers
Dave
-
12 Replies
-
Hi Dave, apart from the 10mm foamboard, these sound like the Tradesignz ‘Parla’ a-boards. These are as described but don’t come with boards.
-
Thanks Lorraine that is the one, you are a star.
cheers
Dave
-
Glad I could help Dave :lol1:
-
It’s been mentioned before on here, have you looked at B&Q metal trestle thingies.
They look as you have described square metal with end caps, lock etc, just no board. Last time i was in they had stacks of then selling for £7, just put your own board on.
Lee
-
quote Lorraine Clinch:Hi Dave, apart from the 10mm foamboard, these sound like the Tradesignz ‘Parla’ a-boards. These are as described but don’t come with boards.i didn’t realise tradesignz did them, i remember "i think" Craig posting a link recently. i don’t see them on their site Lorraine?
-
http://www.tradesignz.co.uk click on pavement signs, they do the Parla (square frame) and the Arden (round frame)
Their showroom start-up offers aren’t too bad either, as you can mix & match, don’t have to buy what they state, as long as it’s the right quantity.-No, I don’t have shares! Just used them a lot when I started up, now I tend to buy my a-boards from Signwaves Trade, as their frames have the boards included.
-
a large arden anyone?
-
Has anyone else tried these to make cheap "A" boards? i have and you can make a good profit 😀
http://www.dtpsupplies.com/pdf/hingehandle.pdf
I use pop rivets instead of screws btw
-
sorry Lorraine it was the ones George has posted i had in mind 😳
-
😎
-
quote George Elsmore:Has anyone else tried these to make cheap “A” boards? i have and you can make a good profit 😀
http://www.dtpsupplies.com/pdf/hingehandle.pdf
I use pop rivets instead of screws btw
What board do you use George? Do you use the feet they sell? I have a sample handle here which I have yet to try out.
-
I use 5mm foamex and yes i use the feet too i thibk the handle thingies and the feet cost £9 to buy Lorraine
Log in to reply.
