-
3Ms IJ 480 Print issues Please Help
I have had an issue of late whilst printing 3Ms new IJ480 material on our Mutoh Valuejet.
I am getting a smudge to the prints, (which is very hard to photograph) that looks as if it is caused by static.
Their is no fault with my machine which is kept meticulously clean.
Has anyone had similar issues with this material as I cannot duplicate it on any other material.
As this material is PVC free is this causing issues with static etc.SC
-
2 Replies
-
I’ve just printed about 15m of 480 on my 1304 and all was well.
Do you have the specific 480 profile? I print from PosterPrint and used the IP2905 “quality” profile. Not sure if this helps at all… good luck.
-
No I don’t have a specific profile as Wasatch does not have one for this material.
I am using my IJ180 profile.SC
Log in to reply.
