-
Replacing dampers or vs-640i
Hey guys
How do I go about replacing the dampers?
Do i need to clamp the hoses, if so what with?
Also I’ve got an issue with white not coming through, there seems to be a lot of gaps in the tube, is there anything i can do to pull it through?
Thanks
-
8 Replies
-
Daniel by the questions you asked please don’t attempt with out the manual a lot more can go wrong than with the older head system
There’s a special sequence for air removalWhy do you want to change them
-
Made a complete hash, could do with speaking with you if you’re around.
-
Not a member so can’t pm
Google mrsticker I am at work now till 9.30 ish -
Hi Daniel, I only just saw this post. It was nice meeting you today, sorry I was the bearer of bad news. Let me know if I can help in any way.
Stafford
-
I have metallic ink not coming through at all at the moment, Roland only told me 2 years after i got my printer that i should be shaking the cartridges weekly, i’m not majorly phased by it as 99% of my work is not metallic at the moment, but it would be good to get it firing properly again, is it done and dusted? or can it be fixed?.
-
Sorry to say it but it’s likely to be the head that needs replacing. I would replace the damper before committing to an expensive new head but I would prefer yourself for the worst.
Stafford.
-
i did a test print of Metallic, a large block today, and it seemed to fire again, except for some minor streaking in it, can that be fixed?
-
Heres an attached preview of the test print (solid Metallic)
Attachments:
Log in to reply.