-
Graphtec ce3000 mk2 – Cutting issue
Ok I may or may not have dropped my plotter lol
Sadly it’s not cutting properly anymore without manually putting pressure on the plotter head to keep it stable but even then it although it cuts the image properly it doesn’t leave it totally cut all the way through at points ie like it’s only perforated
I’m hoping the head can be tightened up again somehow
Anyone got any ideas?
Cheers
John
-
4 Replies
-
hi john, with the way you have described what its doin it sounds that the carriage where the plotter head runs is bent 😕
-
If you can change the cutter to the pen do you get the same results?
-
Don’t even have a pen to try it
-
Right phoned up Graphtec, seems that the carriage head has a tension spring on top of it, loosened it off and re-tightened and job done… back to normal now 🙂
Log in to reply.