Home › Forums › Sign Making Discussions › Vehicle Wrapping › Wrapping over rubber seals on vans

  • Vehicle Wrapping

    Wrapping over rubber seals on vans

    Posted by Warren Beard on 17 August 2008 at 17:39

    Hi All

    What is the common or best practice for wrapping over the rubber seals on van panels? Obviously the vinyl does not stick to it so what do you do to avoid future problems with moisture getting in through these areas and lifting the vinyl?

    cheers

    Warren

    Peter Mindham replied 17 years, 1 month ago 4 Members · 4 Replies
  • 4 Replies

  • Phill Fenton

    Member
    17 August 2008 at 18:18

    I always cut the vinyl away when it runs over rubber seams. I don’t know if this is best practice – but it is what I do.

  • John Childs

    Member
    17 August 2008 at 18:55

    If in doubt – cut it out. 😀

    Seriously, it isn’t going to stick, and will look unsightly, so don’t give it the chance.

  • Lorraine Burke

    Member
    17 August 2008 at 19:26

    I also trim where the rubber is.

  • Peter Mindham

    Member
    17 August 2008 at 19:55

    cut cut cut
    Peter

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .