• Roland Cutters

  where can i buy a cutter protection strip for a pnc5000?

  Posted by Dazzel on 28 July 2007 at 09:26

  Anyone know where i can source these ?

  Many thanks

  Mike Fear replied 18 years, 2 months ago 3 Members · 3 Replies
• 3 Replies

• 

  Chris Wool

  Member

  28 July 2007 at 09:50

  if you are stuck then clean up as best as possible apply a 6mm strip of vinyl over the cutting strip a little polish with mrsheen to make it slip better.

  chris

• 

  Dazzel

  Member

  28 July 2007 at 09:54

  chris thanks, will give it a go 🙂

• 

  Mike Fear

  Member

  29 July 2007 at 07:29

  Give Roland a ring – they may not have the 5000 ones available anymore but they normally have the ones for the PC600 and you can often improvise and use the ones from other machines.

  I needed some for our PNC1000 and they only had the PC600 ones, which are thinner but still work OK.

Log In to Reply