• General Cutter topics

  How do I add abrasive guard

  Posted by Dave Bruce on 6 May 2006 at 20:12

  Can someone tel me how I add abrasive guard to the finished print on my Gerber Edge? I have been in to Print setup and Finishes where the flood coating etc is but it won’t allow me to untick no finishing.

  I am using Signlab7.1

  Cheers

  Dave

  Dave Bruce replied 19 years, 5 months ago 3 Members · 7 Replies
• 7 Replies

• 

  Marekdlux

  Member

  6 May 2006 at 20:15

  Sorry Dave, I’m on Omega.
  Print Options/backing-finish/abrasion guard
  -Marek

• 

  Peter Normington

  Member

  6 May 2006 at 20:33

  Dave you need to make sure you have a spot foil pallette as your default.

  Peter

• 

  Dave Bruce

  Member

  6 May 2006 at 20:35

  I am sure I do Peter but will check in the morning.

  Thanks

  Dave

  Oh yer, why is the background black when I go to print/cut?

• 

  Peter Normington

  Member

  6 May 2006 at 20:41

  You must have black as your substrata, click on the layer set up and choose the print and cut option, and type and colour vinyl you are using.

  I normally set the pallette, halftones and substrata to load by default.

  Peter

• 

  Dave Bruce

  Member

  6 May 2006 at 20:44

  Thanks Peter, I’m sure substrata is set to white, it just changed at some point, just to anoy me.

  Cheers

  Dave

• 

  Peter Normington

  Member

  6 May 2006 at 20:46

  Dave, it hapens if you open a file that wasnt created as print and cut, it opens with the original pallette and no print info.

  Peter

• 

  Dave Bruce

  Member

  6 May 2006 at 20:54

  Ah that’s the reason then Peter as most of my files are created on 7.1 without thermal add on.

  Thanks for that, I will correct it tomorrow.

  Dave

Log In to Reply