shane rabbitt
Forum Replies Created
-
shane rabbitt
MemberJuly 23, 2010 at 8:41 pm in reply to: new to this and lost. driver for plotter?thanks for all the help folks. i ended up buying vinyl master pro and its working fine at the minute.
-
quote Graham.Shand:Does this version use a dongle ?
Have you loaded the driver for the cutter, is it visible and selected?
Does the device show up on the hardware manager ?
Have you checked the cables and selected the correct USB port ?yes the version uses a dongle. in device manager dongle is showing up as detected.
driver for the cutter is set up.
yes the device is showing up in the hardware manager and has no problems that i can see.
i have checked the cables and they seem be be ok. im running the serial to usb into com port3.
-
shane rabbitt
MemberJune 8, 2010 at 10:26 am in reply to: new to this and lost. driver for plotter?cool ill give them a go when i get back to the house. 😉 😉
i have corel draw. is this program any good? or is it a bit advanced for the beginner?
thanks.
-
thanks for the welcome guys.
quote Phill:Hi Shane – welcomeRace cars may seem glamorous – but rarely are they lucrative.
Try and target a range of small businesses that will value your service 😀
will only be doing them for a few weeks to get some money rolling. i race in the irish touring car championship here in ireland so i have a lot of connections ect. and will be using my car and the brothers car for advertising.
this is his mini that we did. soon to be completly redone.
and my motor. also being completly redone.