-
Wizzard 2000 Assistance
I purchased the Wizzard 2000 (Dahlgren) with built in computer in 2001 and the machine worked great until last week when the Hard Drive failed and no files could be extracted off the drive. I was not provided any software with the unit except the manual.
I have replace the hard drive and downloaded the Dos SuperPro 4.07 packet from Suregrave and installed the files. The program works except when transmitting the file to the engrave table I get "Control Unit 1" not responding.
Am I missing a driver file for the table or is there a setting in the control panel I am missing..
I understand there were not many of this model made.
Is there any one on the forum that has one of this machines that can send me some info / files off of their machine. ??
Thanks, Mark
-
2 Replies
-
Get in touch with Graham at Rona machines as he knows a fair bit about these, including upgrading with newer controllers
01992 899 255
I have the ST version which I bought 2nd hand.
-
The folks at Suregrave sent me the files I needed. Thanks Technical Support
http://www.peninsulatrophy.com/GRAPHICS/WIZZARD.jpg this is the unit in question… Not many people have seen one..
Mark 😀
Log in to reply.