Home › Forums › Vinyl Cutter Discussions › General Cutter topics › Wiring Serial Cable Evision 375

  • General Cutter topics

    Wiring Serial Cable Evision 375

    Posted by Tim Lucas on 29 May 2010 at 13:23

    Hi Guy’s,

    I have just had my omega software report – unable to spool file envision….

    Basically either my com port or cable or envision is scrap!! But which one???

    So here is my question?? What is the wiring configuration for the cable – Yes it’s a RC 232C but it’s not standard…. it’s a Gerber special!

    Also how do I check the com port on the PC>> just in case.

    Thanks,

    Timmy

    Tim Lucas replied 15 years, 4 months ago 2 Members · 2 Replies
  • 2 Replies

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .