Home › Forums › Vinyl Cutter Discussions › PCUT Vinyl Cutters › why is pcut ct630 cutting over graphics twice?

  • PCUT Vinyl Cutters

    why is pcut ct630 cutting over graphics twice?

    Posted by Roy Williams on 16 May 2007 at 15:01

    Its keeps going over the same graphic twice for some reason.. only just started doing this though. any idea I’m using Sign Blazer elements.

    Thanks.

    Roy Williams replied 18 years, 5 months ago 2 Members · 2 Replies
  • 2 Replies

  • Andy Gorman

    Member
    16 May 2007 at 15:41

    I don’t have that plotter or software, but the only time I had that happen it was because I had a stroke and a fill assigned to the graphic before exporting and then importing into my cutter software.

    Worth checking, you never know.

  • Roy Williams

    Member
    16 May 2007 at 18:21

    sorted problem now all settings on cutter had altered probably due to pc crashing earlier,reset setting cutting fine now ,ave to watch that in future.thanks for quick responce

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .