Home › Forums › Sign Making Discussions › General Sign Topics › wh does 5mm PVC slip when cutting on Javelin?

  • General Sign Topics

    wh does 5mm PVC slip when cutting on Javelin?

    Posted by Noel Moore on 22 October 2008 at 15:35

    Every time I cut 5mm PVC on my Javelin, it ALWAYS MOVES. I am trying to cut an 8′ x 4′ sheet into 2′ x 4′. Can anybody help me to solve this problem?

    Noel Moore replied 17 years, 2 months ago 3 Members · 3 Replies
  • 3 Replies

  • Peter Dee

    Member
    23 October 2008 at 08:37

    The board must be laid DEAD FLAT. The slightest curve in your worktable will cause this.

  • Jason Xuereb

    Member
    23 October 2008 at 08:57

    Buy the side clamps. Well worth it.

  • Noel Moore

    Member
    24 October 2008 at 13:12

    Thanks for the help. I have discover cutting the sheets of PVC twice or three times STOPS THE PVC MOVING.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .