VinylMasterPro help wanted please

[Mark Horley]

Hi Kevin
What I’d do is take a digi pic as square on as possible and measure one of the panels…when you import this into your sign making software…you can re-create the same size panel you have measured…then simply blow the digi pic up until the two panels match…or there abouts…this will give you some idea on the size of all the panels and the area you have to work with…But to get this more accurate there are disk’s available on the market that have almost every vehicle on them…I use one by Ingram Publishing they have a website to connect and purchase from…But I also think that from my short time on this site there maybe somone here that also does it…these disks are far more accurate for size but do not show curves or recesses…what I do is a bit of both….and I take a few measurements for cross reference…I hope this has helped….

[Darryl Seager]

I have been a little disappointed in the vehicle software from ingrams,i can’t find a few cars!! new(bmw) mini,land rover discovery,defender, only 1 outline of a range rover and none of the newish mg’s,so beware
darryl

[jon vital]

I think it would take them forever to digitise every new car that comes out. I imagine it’s quite a lot of work keeping up with all the new vans.

[Brian Hays]

A tough job but sombody has gotta do it! 😎

[Kevin Flowers]

Hi
check with your outline cd supplier some offer free updates for the first year.

KTF

[kevin]

Like to say to thanks for help recieved re- VMPRO scaling problem wich is now sorted,hopefully as i progress i can make a likewise contribution to the site thanks again.
PS Im about 95% towards buying the program is anyone out there using it,any feedback ie problems with drivers,tech support etc would come in handy cheers.

KEVIN