Home › Forums › Vinyl Cutter Discussions › Summa Cutters › Summa D1400 Cutting Blade Skips

  • Summa Cutters

    Summa D1400 Cutting Blade Skips

    Posted by Mark Reader on 23 April 2014 at 20:32

    Hi
    Can anyone help?, yesterday i tried to fix my worn out opos sensor to do this i took off the cutting head. now the opos is working ok but i have caused another problem!.
    The blade seems to crash heavily into vinyl and then skips for about an inch until it settles down, if i slow it right down it gets rid of the skipping but still puts a small hole in the vinyl where it has landed heavily.

    Thanks Mark

    Chris Wool replied 11 years, 5 months ago 1 Member · 1 Reply
  • 1 Reply

  • Chris Wool

    Member
    23 April 2014 at 21:37

    Sounds like the plunger is sticking in the windings or think there is a spring to pull the head back upmay be missing or not connected correctly

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .