Home Forums Printing Discussions General Printing Topics Spray for turning vinyl to gloop

  • Spray for turning vinyl to gloop

    Posted by Chris Wilson on 29 August 2019 at 18:44

    Someone on here tucked away in a thread once mentioned some chemical that turns vinyl to a mushy mess after 10 minutes of being on then needs washed off..

    Turned up to start a fleet today that’s being re-branded. I have no idea what the first guys used but I’ve never seen anything like it it. Welded on. Must of been some sort of high tac/ possibly even that stainless steel vinyl, perhaps a cheap brand version of it. Although covered my back side I’d rather not spend 3 hours stripping one tiny van that should take 15 minutes. My fingers hurt after 3 of them today.

    David Hammond replied 6 years, 2 months ago 2 Members · 2 Replies
  • 2 Replies
  • Mark Piddington

    Member
    29 August 2019 at 19:23

  • David Hammond

    Member
    29 August 2019 at 19:25

    Had the same issue. Tried the chemicals, resorted to using a steamer in the end.

Log in to reply.