-
sp300 post heater problem
The heater on my SP300 is playing up. The post heat platten doesn’t get fully up to temperature though it does heat up slightly suggesting it’s not a problem with a fuse. This has occurred after replacing the capping stations today. Any ideas?
-
2 Replies
-
Could be coincidence
Or the wires from the sensor I think come out of the bed just next to where you have been fiddling
Warning the heater element wires are mains voltage -
Thanks for the advice Chris. I don’t think it’s a coincidence, I’m pretty sure I must have disturbed something when I changed the capping stations. I’ll have a closer look tomorrow when I’m back at the unit.
Log in to reply.