Home Forums Vinyl Cutter Discussions Graphtec Vinyl Cutters Sourcing a Graphtec ce5000 pinch roller sensor? Help please?

  • Sourcing a Graphtec ce5000 pinch roller sensor? Help please?

    Posted by Daniel Evans on 20 August 2015 at 18:54

    Hey guys

    Had an issue earlier today where the media got caught up with the blade, now it won’t read the pinch rollers.

    I’ve turned the pinch roller sensor off for the time being so I could finish the job but I now need to get this fixed.

    I’m happy enough replacing the sensor myself, just need to know where I can get one from, how much and if my one can be fixed before I spend any money on a new sensor?

    Thanks

    Daniel Evans replied 10 years, 1 month ago 2 Members · 2 Replies
  • 2 Replies
  • Chris Wool

    Member
    20 August 2015 at 19:45

    Look under graphtec and see cam sensor post for a few ideas
    Think it’s the same bit on a different board
    I would have a look to see if the vinyl didn’t dislodge the wires

  • Daniel Evans

    Member
    24 August 2015 at 19:37

    Hi Chris

    Thanks, decided to strip the head section down and double check the sensor was still connected, it had a black cover on it and I’m guessing this might of partially covered it incorrectly as after I refitted it it’s all working correctly again.

Log in to reply.