Home › Forums › Printing Discussions › Printer Ink › solvent ink gassing off

  • Printer Ink

    solvent ink gassing off

    Posted by John Imrie on 4 January 2008 at 15:16

    the general advice seems to be allow a solvent print 24 hours to gas off
    before laminating . does the print being left on the takeup spool affect this
    time?

    any advice please

    John

    John Imrie replied 17 years, 11 months ago 3 Members · 3 Replies
  • 3 Replies

  • Steve Morgan

    Member
    4 January 2008 at 16:49

    I prefer to hang mine up – pegged on a line in the workshop or laid flat on the bench for a minimum of 24 hours. More ink, more time. I should think 36 hours is more than enough

    Steve

  • Chris-Hooper

    Member
    4 January 2008 at 17:00

    losen the roll up a bit and leave for at least 24hrs before laminating
    as said before if the ink coverage is heavy I would leave a bit longer.

  • John Imrie

    Member
    5 January 2008 at 10:29

    Thanks for advice
    John

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .