Home › Forums › Software Discussions › General Software Topics › Signblazer Security Dongle help needed!!

  • General Software Topics

    Signblazer Security Dongle help needed!!

    Posted by chrisfoster on 5 July 2011 at 07:58

    Hi all, for the last 10 years or so i’ve always used Signblazer for my vinyl cut stuff. I’m aware its no where near as advanced as SignLab etc but it does all I need it to do, plus I can use it with my eyes shut now!!

    However, last week my security dongle for the software died on me. It uses one of those USB Aladdin HASP dongles to allow me to open the software. How do I go about sourcing a replacement dongle? Is it specific to the software or can I find one on ebay and use that? I originally bought the software from Signwizard, not sure if they are still around?

    Any help would be great!

    Thanks
    Chris

    Mike.Smith replied 11 years, 10 months ago 1 Member · 1 Reply
  • 1 Reply

  • Mike.Smith

    Member
    17 December 2013 at 20:47

    how did that work out for you??

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .