Home › Forums › Vinyl Cutter Discussions › Mimaki Cutters › sc1400d mind of its own

  • Mimaki Cutters

    sc1400d mind of its own

    Posted by John McNickle on 1 April 2009 at 14:24

    Hi i have just installed a Mutoh sc1400d, no matter how i set it up it leads on about 3mtrs after a job instead of stopping just after it also my flexisign seems to stall when cutting to it and i cant run it and my cadet at the same time anymore ( used to with my old sc650 )

    Can anyone help here

    John

    John McNickle replied 16 years, 6 months ago 2 Members · 4 Replies
  • 4 Replies

  • Tim Painter

    Member
    1 April 2009 at 14:42

    At a guess I would say outputting more material at the end is a plotter setting.

    I assume your OLD SC650 was serial or parallel.

    What connects are you using for the 1400 & cadet compared to previous?

  • John McNickle

    Member
    1 April 2009 at 21:50

    Tim

    The old plotter ran off com port now both running off USB, new computer doesnt have the older ports

  • Tim Painter

    Member
    2 April 2009 at 10:37

    John what version is your firmware?

    Tim.

  • John McNickle

    Member
    2 April 2009 at 14:14

    Tim its version 3.01

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .