Roland VP service call – any ideas??

[David Rowland]

im not a owner of the machine, but describe the events up to reading it?

[Jason Davies]

Thanks for the quick response Dave, just searched through google and it seems to be an issue with the wipers, we routinely clean this machine and I have a new set of spare wipers.

It did make a clicking noise when I turned it on, so I am assuming it caught one of the wipers on the way back, just cleaning again now, will post back asap.

Jason

[Jason Davies]

Okay, it seems to be fine now, just ran some test prints and still okay, not the message you really want to see on your machine, I was just about to run some wraps today to give us a bit more time in the week.

Thanks

Jason

[Derek Heron]

hi mate
sounds like your on the right path it is a wiper protection error
even though the machine carries out the regular movement, the output of the wiper origin sensor does not reach the expected value.
things that could be wrong:
disorder of the wiper origin sensor
fault of the wiper unit
fault of the origin sensor
cut-line or short of cable and flexible cable.

what might need to be done
wiper origin motor replacement
or wiper unit replacement
or wiper origin sensor replacement
or cable and flexible cable replacement

dont think for one moment i am a techy just copied it
hope it helps

derek

[Jason Davies]

Thanks Derek, I think I’ll give signmaster a ring in the morning anyway and report it.
Regards
Jason