Home › Forums › Vinyl Cutter Discussions › Summa Cutters › Problem with my Summa S 140T

  • Summa Cutters

    Problem with my Summa S 140T

    Posted by Mattias Pettersson on 7 September 2009 at 16:02

    Hi
    I got a problem with my Summa cutter
    some times when the knife landing it will do that with full pressure and and some time with right landing pressure
    I have tried to change flat cable and new firmware with no luck
    Can somebody help me?

    Mattias Pettersson replied 16 years, 3 months ago 2 Members · 2 Replies
  • 2 Replies

  • Chris Wool

    Member
    7 September 2009 at 18:04

    hi and welcome.
    it is only polite to say hello and who you are what you do etc. and please would not go amiss 😉 .

    don’t know if the summa has this or not but if that happened on one of my graphtecs, i would clean the knife depth encoder strip.

    chris

  • Mattias Pettersson

    Member
    7 September 2009 at 18:29

    Thaks for your welcome and your answer

    I have a Sign company here in Sweden
    http://www.imareklam.se
    i have one Mutho rockhooper III
    one Summa S 140 T
    One Laserpro Spirit GX
    one Axyz 4004 CNC router
    And a Rolls roller Flatbed Applicator
    and we are 4 employee

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .