hi,
Dont know much about your rip or printer,
but did you set the crop marks before printing, may be I’m mis-understanding. but you need to print the crop marks first
before sending to printer check the following
set material to correct media
set crop marks from mark box
set cut controls to print only
send job to printer
get job out and laminate
not the round circles and rectangle the rectangle indicates the front !
place back in printer
go back to the job in the rip and click on it
now go to cut control and select cut only and send to printer
the printer will look for all marks and when it finds them will cut
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.